Cisco MDS 9100 Series Hardware Installation Manual page 35

Chapter 2 Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Verifying the Fan Module
To verify that the new fan module is installed correctly, follow these steps:
Listen for the fans; you should immediately hear them operating. If you do not hear them, ensure that
Step 1
the fan module is inserted completely in the switch and the faceplate is flush with the switch back panel.
Verify that the fan module LED is green. If the LED is orange, then one fan has failed in this fan module;
Step 2
if the LED is red, then both fans have failed in this fan module.
Contact your customer service representative for assistance if, after several attempts, the fans do not
Step 3
operate or you experience trouble with the installation.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
Note
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/en/US/support/tsd_cisco_worldwide_contacts.html
OL-21514-01
Removing and Installing Components
Cisco MDS 9100 Series Hardware Installation Guide
2-35