G48P Module; G48P Leds - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

For information about the LEDs and their activity on the G48T module, see
page 126.

G48P Module

Figure 67 shows the G48P module.
Figure 67: G48P module
The G48P module has 48 autosensing 10/100/1000BASE-T ports that use standard RJ-45 connectors and
that can deliver Power over Ethernet (PoE) to an attached device as well as the usual Ethernet
connection, provided by one cable. The G48P module supports the IEEE 892.3af PoE specification.
When powered devices (PDs) are connected to a port, the PDs are discovered and classified as 802.3af-
compliant or as legacy devices. ExtremeWare XOS implements the following functions:
Enables the port for discovery, classification, and power delivery
Enforces port power limits by denying power to a device exceeding the configured limit
Enforces class limits by denying power to a device exceeding the class limit
Reports and tracks port power faults
The default configuration of the G48P module is as follows.
All ports:
Are added to the default VLAN as untagged
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
Operate in autonegotiation mode

G48P LEDs

The G48P module has the following LEDs:
Module status
Extreme Networks Consolidated XOS Hardware Installation Guide
Module status LEDs
10/100/1000BASE-T
PoE ports
ASP039
I/O Modules
"I/O Module LEDs" on
125