Sanyo FW55C87F Owner's Manual page 29

You may adjust picture quality and enhancement settings
using Clear Pix Ultra HD and Advanced settings sub menus.
Auto picture Dynamic contrast
Backlight Color enhancement
Contrast Black stretch
Brightness Brilliant Motion Rate
Color 4K UHD Upscaling
Tint Global Dimming
Sharpness Noise reduction
Clear Pix Ultra HD MPEG artifact reduction
Advanced settings
Pix shape
Mode selection
Horizontal position
To select the desired setting, then press OK
Dynamic
contrast (Off, Minimum, Medium and Maximum)
Off
To set color enhancement to off
Color
enhancement
On
To make colors more vivid and bright
To select the desired setting, then press OK
Black
stretch (Off, Minimum, Medium and Maximum)
Brilliant To select the desired setting, then press OK
Motion Rate (Off, Minimum, Medium and Maximum)
4K UHD To select the desired setting, then press OK
(Off, Minimum, Medium and Maximum)
Upscaling
Global To select the desired setting, then press OK
Dimming (Off, Minimum, Medium and Maximum)
Noise To select the desired setting, then press OK
(Off, Minimum, Medium and Maximum)
reduction
MPEG
To select the desired setting, then press OK
artifact
(Off, Minimum, Medium and Maximum)
reduction
Auto picture Color alignment
Backlight Custom color management
Gamma
Contrast
Brightness Blue stretch
Color Film mode
Tint HDR mode
Sharpness
Clear Pix Ultra HD
Advanced settings
Pix shape
Mode selection
Horizontal position
To set the color temperature to Personal,
Cool, Normal and Warm.
Mode
When you adjust the following settings,
Personal will be set automatically.
To decrease red
Red gain
contrast
Green gain To decrease green
Color
contrast
alignment
To decrease blue
Blue gain
contrast
Red offset To decrease red
brightness
Green
To decrease green
offset brightness
Blue offset To decrease blue
brightness
Off
Minimum
Medium
Maximum
Mode
Red gain
Green gain
Blue gain
Red offset
Green offset
Blue offset
Cursor I Cursor H
To increase red
contrast
To increase green
contrast
To increase blue
contrast
To increase red
brightness
To increase green
brightness
To increase blue
brightness
To select the desired setting, then press OK
(Red, Yellow, Green, Cyan, Blue and Magenta)
To rotate only
Tint selected color tint in
Custom color
clockwise direction
management
To decrease color
Saturation
with only selected
color
To decrease
Brightness
brightness with only
selected color
To select the desired setting, then press OK
Gamma (Very Dark Room, Dark Room, Normal, Bright Room
and Very Bright Room)
Off
To set blue stretch to off
Blue stretch
If you switch on blue stretch, the part of
On
the video signal without color turns bluish.
Off To set film mode to off
Film mode
To optimize the picture recorded by the
Auto
original film
Off To set HDR mode to off
Automatically switches to a dedicated
HDR mode
Auto picture quality setting when receiving
HDR signal
Note(s)
Mode selection is available only if
●
The external input modes are selected HDMI 1, HDMI 2 or HDMI 3.
–
The connected HDMI device is outputting a video signal.
–
29
Cursor I Cursor H
To rotate only
selected color tint in
counterclockwise
direction
To increase color
with only selected
color
To increase
brightness with only
selected color
Continued on next page.
.
English