Advertisement
COMPUTER
FUNCTIONS OF THE ELECTRONIC WATCH:
FUNCTIONAL BUTTONS:
MODE - Push down for selecting functions.
SET - To Set the consumer movement of time, count, distance, calories.
RESET -For resetting consumer movement of time, count, distance, calories.
FUNCTION AND OPERATIONS:
1.SCAN:
Press "MODE" button until "SCAN" appears, monitor will rotate through all the 6 functions: Time, count,
distance, RPM, calorie. Each display will be hold 6 seconds.
2.TIME:
(1) Count the total time from exercise start to end.
(2) Press "MODE" button until "TIME" appears, press "SET" button to set exercise time. Automatically
count down from targeting value during exercise.
3.COUNT: (1) Count the count from exercise start to end.
(2) Press "MODE" button until "COUNT" appears. Press "SET" button to set exercise count.
Automatically count down from targeting value during exercise.
4.DISTANCE: (1) Count the distance from exercise start to end.
(2) Press "MODE" button until "DIST" appears. Press "SET" button to set exercise distance.
Automatically count down from targeting value during exercise.
5.COUNT/MIN(RPM)：Automatically accumulates the workout counts per minute.
6.CALORIES: (1) Count the total calories from exercise start to end.
(2) Press "MODE" button unit "CAL" appears. Press "SET" button to set exercise calories. Automatically
count down from targeting value during exercise.
NOTE：
1. If the display is faint or shows no figures, please replace the batteries.
2. The monitor will automatically shut off if there is no signal received after 4 minutes .
REPLACE BATTERY:
1. Always purchase the correct size and grade of battery most suitable for the intended use.
2. Replace all batteries of a set at the same time.
3. Clean the battery contacts and also those of the device prior to battery installation.
4. Ensure the batteries are installed correctly with regard to polarity (+ and -).
5. Remove batteries from equipment when not in use for extended periods of time.
6. Remove used batteries promptly.
7. The Computer requires two 1.5V (AAA) batteries. Batteries are not included in packaging.
8. If the display is not clear or only partial segments appeared, remove the batteries and wait for
15 seconds before re-install them.
9. The battery life is approx. 3 months under normal usage.
10. When the batteries are removed, all the functional values will reset to zero.
Note:
Please note all values on this computer are approximate and they are for comparison
purpose only. Do not use these values for any medical or rehabilitation purpose.
© IMPEX INC.
17
www.marcypro.com
Advertisement
