Checking Painted Surface Of Motor; Periodic Maintenance; Replacement Parts; Maintenance Interval Guidelines - Yamaha F225 Owner's Manual

3. With the engine off, turn on the water tap
and let the water flush through the cool-
ing passages for about 15 minutes. Turn
off the water and disconnect the garden
hose adapter from the garden hose con-
nector.
4. Reinstall the garden hose connector onto
the fitting on the bottom cowling. Tighten
the connector securely.
ECM00540
CAUTION:
Do not leave the garden hose connector
loose on the bottom cowling fitting or let
the hose hang free during normal opera-
tion. Water will leak out of the connector
instead of cooling the engine, which can
cause serious overheating. Be sure the
connector is tightened securely on the fit-
ting after flushing the engine.
NOTE:
When flushing the engine with the boat in the
water, tilting up the outboard motor until it is
completely out of the water will achieve better
results.
EMU28460

Checking painted surface of motor

Check the motor for scratches, nicks, or flak-
ing paint. Areas with damaged paint are more
likely to corrode. If necessary, clean and paint
the areas. A touch-up paint is available from
your Yamaha dealer.
EMU28488

Periodic maintenance

EWM01071
WARNING
Be sure to turn off the engine when you
perform maintenance unless otherwise
specified. If you are not familiar with ma-
chine servicing, this work should be done
by your Yamaha dealer or other qualified
mechanic.
Maintenance, replacement, or repair of the
emission control devices and systems
may be performed by any marine engine
repair establishment or individual. All war-
ranty repairs, however, including those to
the emission control system, must be per-
formed by an authorized Yamaha marine
dealership.
A service manual is available for purchase
through your Yamaha dealer for owners who
have the mechanical skills, tools, and other
equipment necessary to perform mainte-
nance not covered by this owner's manual.
EMU28511

Replacement parts

If replacement parts are necessary, use only
genuine Yamaha parts or parts of equivalent
design and quality. Any part of inferior quality
may malfunction, and the resulting loss of
control could endanger the operator and pas-
sengers. Yamaha genuine parts and acces-
sories are available from your Yamaha
dealer.
EMU35520

Maintenance interval guidelines

The service intervals provided in the Mainte-
nance Chart were developed based upon
"typical" use that includes operating at varied
speeds, with sufficient time for engine warm
up and cool-down, a medium to light load, and
an average cruising speed near the 3000 to
4000 rpm range. As with any engine, howev-
er, if your normal operating conditions are dif-
ferent, you should consider service more
often than shown, especially how often you
change your engine and gear oil. Examples
might include extended wide-open-throttle
use or long periods of trolling or idling, carry-
ing heavy loads, or frequent starting and stop-
Maintenance
57