Table of Contents
Advertisement
2.After starting the engine, run the engine at
the idling speed for a few minutes.
3.The engine should be run at idle speed for a
few minutes to allow sufficient warm-up time
to prevent engine damage before applying a
load. This will allow oil to reach engine parts,
and allow piston clearance to reach design
specification.
STOP
1.Release the throttle lever back and run the
engine at the idling speed.
2. Turn the switch to the "OFF/STOP" position.
3. Suddenly stopping engine from high speed
operation can cause engine damage.Reduce
engine speed to idle speed for one minute.
WARNING
Move the choke lever to the
unplug the spark plug if the engine can not be
shut down by the two upper steps,then adjust
the carburetor after the machine becomes
cold or contact the authorized dealer for help.
BLADE ROTATION
WARNING
Do not ajust the blade when engine is
running at high speed, otherwise will cause
transmission failure.
1. When ajust the blade, throttle trigger should
be released at the idle speed position.
2. Push down the clip,meanwhile swivel the
blade to the desired position;there are multiple
positions can be selected.
Clip
OPERATING
1.When cutting the hedges ,the unit should be
held so that the blades form 0-15° with the
cutting direction.
1. Always hold the unit firmly with both hands.
2. When the throttle trigger is released, it
3. Use special caution when cutting hedges,
which are along with a wire fence.
The blades should not contact the fence,
otherwise the blades will be damaged.
4. The hedge trimmer is determined to cut
the hedges or small bushes.Do not use the
position or
unit to cut thick branches, trees or grass,
which may damage the blades and
other parts.
5. If the blades are clogged by the leaves or
branches, immediately stop the
unit,remove spark plug lead and remove
the stuff out of the blades.
SHOULDER HARNESS
1. Wear the harness on the shoulder then ajust
the straps and buckles according to your
stature until you feel comfortable with it on.
2.Attach harness hook to the suspension
loop on the shaft. Make sure the unit
gets a good balance before operating.
Use the quick-release mechanism on the
harness to free yourself quickly from the unit
in case of emergency.
-10-
WARNING
will take a little while before the blades
completely stop.
Quick-release mechanism
WARNING
Advertisement
Table of Contents
