Mounting The Control - Bosch Rexroth ctrl CORE Operating Manual

ctrlX CORE
•
The cabling of the Ethernet wires may not leave the building.
•
Observe the bending radius of the cables used when routing the connecting lines.
•
Use strain reliefs for all cables.
•
Install the control only horizontally on a mounting rail attached to a wall.
•
Keep the maximum distance possible from interference sources.
•
Provide the following minimum distances for sufficient cooling:
In case of a several line design, the supply air has to be measured under each line and its limit value
has to be observed. For information on ambient temperatures, refer to
conditions of the ctrlX CORE" on page
Fig. 9: Minimum distances for the circulation of ambient air
•
Additionally, provide sufficient distance for mounting, dismounting, plugs and cables.
10.3

Mounting the control

NOTICE
R911405645, Edition 03
12.
35 mm
0 mm
35 mm
35 mm
Damage of the device by plug mounting under voltage!
−
Before mounting or dismounting components, disconnect the control -
including its components - from voltage.
−
Connect the voltage only after the control and its components have been
set up.
Mounting the control
⮫ Chapter 6.1 "Ambient
0 mm
Bosch Rexroth AG
21 / 40