Initial settings
3
Confirm the language
Language for
LANGUAGE
on-screen analogue
channel displays and
menus (excluding the
DTV menu)
When not using analogue channels
When using analogue channels (or cable TV)
4
Set analogue channels
1
Register analogue channels
COUNTRY
(blue)
AUTO PROGRAM
14%
2
Check what was registered
EDIT
PR
ID
AV
01
BBC1
02
BBC2
03
ITV
04
CH4
05
CH5
06
07
08
09
3
Set T-V LINK
T-V LINK
DOWNLOAD TV
RECORDING DEVICE
5
Initial setting is complete
Edit digital channels
Editing digital channels (P. 45)
If digital channel reception is poor
If analogue channel reception is poor
Some digital channels cannot be watched on this TV.
13
(continued)
When change a language
select
@
⁄
When change a country
select
CH
28
Edit analogue channels
Confirm
CH
in "Editing analogue
@
CH
21
CH
22
channels" (P. 47)
CH
23
CH
24
CH
25
CH
26
CH
27
CH
28
When not using
When using "T-V LINK"
"T-V LINK"
If "FEATURE NOT
AVAILABLE" appears :
Is a "T-V LINK" compatible
device connected to "EXT-2"?
Is the device turned on?
When the digital channel reception is poor (P. 14)
Troubleshooting (P. 49)
(P.55)
When the TV cannot find the digital channels
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
Turn "ATTENUATOR" to "ON" (P. 34), since the radio waves are too strong.
Register digital channels again
"Service Scan" (P. 43)
If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.
When the digital channel reception is poor
The "Missing or weak signal" message appears.
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
Turn "ATTENUATOR" to "ON" (P. 34), since the radio waves are too strong.
Check digital channels signal
Signal Check (P. 43)
If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.
When "RF Attenuator" setting screen is displayed
Set "ATTENUATOR" (P. 34) from this setting screen.
To set the "ATTENUATOR" on select "On", to set it off select "Off"
This setting screen will appear during the "Factory Settings" (P. 43) with "ATTENUATOR" set to "ON".
Consult your retailer
Consult your retailer
14