Installing Your Camera
•
Baud Rate Settings
Select the transfer speed of a selected communication protocol.
No.
Baud Rate(BPS)
1
2,400
2
4,800
3
9,600
4
19,200
Communication Method Settings
•
Select a communication method for the camera.
Function
SW2- #7
Transfer Mode Switch
•
Communication Response Settings
Select a communication response method for the camera and controller: Response or No
Response.
Function
SW2- #8
Response Mode Switch
•
Termination Settings
To prevent the attenuation of communication signals between the camera and controller, 2
cameras in a longest distance for the camera and controller communication loop must be
set up with the termination settings.
Camera Input Position
SW2- #10
Termination of Longest Path
ON
On the Path
OFF
18
SPEED DOME CAMERA
SW2-#5
SW2-#6
ON
ON
ON
OFF
OFF
OFF
OFF
ON
ON
OFF
RS-422(4Wire)
RS-485(2Wire)
ON
OFF
Response
No Response
SW2- #11
ON
OFF
User's Manual
Installing Your Camera
•
Camera Backup Settings
These settings are useful when the camera or its install base are damaged or malfunctions
occur. When replacing the camera or its install base, you can transfer existing presets and
sequence information to the replacement using these settings.
Backup Function
SW2- #9
Backup(IB→D)
OFF
Backup(D→IB)
ON
Backup Disable
-
- Backup(IB→D) : Enables transferring the current camera's sequence information to a new
camera.
- Backup(D→IB) : Enables transferring the current camera's sequence information to a new
install base.
*IB: Install base, D: Dome Camera
Notes
• T ouseathirdpartycontrollerwiththisproduct,pleasecontactourAfter-SalesServiceor
Technology Department.
• A DProtocolControlMethod
- Input Camera OSD: 3+Auxiliary On
- Output Camera OSD: 3+Auxiliary Off
- Enter: IRIS Open
- ESC: IRIS Close
• F ormoreinformationabouttheprotocols,refertoourofficialwebsite.
Camera ID DIP Switch Settings (SW1)
To set up camera IDs, refer to the "Camera ID Chart" next.
SPEED DOME CAMERA
SW2- #12
OFF
OFF
ON
19
User's Manual