Loading 35 mm film
Follow these steps to load 35 mm positive or
negative film:
1. Insert the film strips in the guide, as shown
at right. The glossy (smooth) side of the
film should be facing up as you insert each
filmstrip into its individual holder.
2. Turn the guide over so that the glossy side
of the film is facing down and place the
guide on the document table, as shown.
Make sure that the upper and right edges of
the guide are aligned with the ruled edges of
the document table.
3. Close the TPU and scan according to the
instructions in your scanner driver's
electronic guide.
Loading 35 mm slides
Follow these steps to load 35 mm slides:
1. Position the slide transparency guide on the
document table, as shown. (The upper and
right edges of the guide should be aligned
with the ruled edges of the document
table.)
2. Carefully position each slide inside the
guide, making sure that the glossy (smooth)
side of the film is facing down. (You can
line up two columns of 35 mm slides in the
larger section of the guide, and one column in the smaller section.)
3. Close the TPU and scan according to the instructions in your scanner driver's
electronic guide.
48