Troubleshooting - Epson PowerLite Home 10 Quick Setup Manual

Troubleshooting

If you don't find the answer to your problem here, see the User's Guide
for more troubleshooting tips.
The image doesn't fill the screen.
Try adjusting the zoom ring.
If possible, place the projector farther
away from the screen.
Press the Aspect button to move through
the projector's aspect ratio settings: Normal, Squeeze, and Zoom.
Experiment to see which setting looks best on your screen.
The colors on your screen don't look right.
Press the Color Mode button on the remote control to move
through the different color mode settings.
Check your cable connection. If your cable is not securely
connected at both ends, some colors may not appear.
Make sure the projector has detected
the correct video source. Press one of
these buttons on the remote control:
Input A/B
S-Video/Video Toggles between S-video and
Adjust the settings under the Picture Quality
option in the projector's Image menu.
See the User's Guide for details.
Only part of the image is displayed,
or the image is distorted.
Try selecting a different aspect ratio by
pressing the Aspect button.
If the image is distorted or contains
interference, make sure the cable is
securely connected.
If your image looks like
on the projector's control panel to correct the problem.
Nothing is displayed, or you see
a "No signal" message.
Press the Source button on the projector or
the Input A/B or S-Video/Video button on
the remote control until you see your picture.
Check the cable connection.
Make sure your video equipment is on. If it isn't, turn your
projector off. Then turn it on again after you've turned on
your video equipment.
The remote control doesn't work.
Make sure you've removed the battery
insulating tape. See section 2 on the
front of this sheet.
Make sure you're not farther than 20 feet
from the projector. Also, point the remote
control at one of the projector's two
infrared receivers.
Move the projector and remote control
away from strong sunlight and turn off
any fluorescent lighting.
Remove the clear film covering the
infrared receivers.
EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite and PrivateLine are registered
trademarks and EPSON Store is a service mark of Epson America, Inc.
General Notice: Other product names used herein are for identification purposes only and may be trademarks
of their respective owners. EPSON disclaims any and all rights in those marks.
Copyright © 2003 by Epson America, Inc. 7/03
Printed in XXX
Toggles between component
video and computer signals.
composite video signals.
or
Source
buttons
, press the or buttons
No signal
Infrared
receiver
Infrared
receiver
CPD-16678