Epson PowerLite 7850p Product Information Manual page 19

EPSON PowerLite 7850p Projector
If you're using a network management utility running SNMP,
you can configure your network to send trap alerts even without a
plug-n. See the User's Guide for more information.
Make sure you have installed the EMP Monitor software
(included on the projector's CD-ROM) on the computer you
want to use to monitor your projectors. (See the User's Guide
for instructions.)
Note: Your computer must be running Microsoft Windows XP,
2000, Me or 98.
Setting Up the Projector on a Wired Network
This section explains how to configure projectors on a wired
network. You can also configure projectors for wireless
communication. See "Configuring the Connection" on
page 12 for details.
1. Insert the PCMCIA LAN card into the card slot on the
back of the projector. Then connect the projector to your
network using a commercially available 100baseTX or
10baseT network cable.
2. Turn on the projector.
3. Press the button on the remote control and select
Menu
from the
Network Advanced2
Video Video
Brightness Control Brightness Control
Audio Audio
Projector ID Projector ID
Effect Effect Network Network
Setting Setting
COM Port COM Port
User's Logo User's Logo
Auto setup Auto setup
Advanced1 Advanced1 BNC Sync Termination BNC Sync Termination
Advanced2 Advanced2 Reset Reset
About About
Reset All Reset All
[ [ ]: Select ]: Select [ [ ]: Enter ]: Enter
4. If your network assigns addresses automatically, turn on
.
DHCP
If your network does not assign addresses automatically,
turn off and enter the projector's
DHCP
,
Subnet Mask Gateway Address
needed.
❏ To enter numbers using the remote control, press the
button until it lights, then use the numeric
Num
keypad.
Num button
18 EPSON PowerLite 7850p Projector
-
menu.
:
High High Low Low
: 1 : 1
Set Set
Select
Set Set
: RS-232C RS-232C USB USB
Network
:
ON OFF ON OFF
:
ON ON OFF OFF
Execute Execute
[Menu]: Exit [Menu]: Exit
,
IP Address
, and
MAC Address
Zero
❏ To change the network addresses from the projector's
control panel, press the right and left arrow buttons to
select the part of the address you want to enter, then
use the up and down arrow buttons to increase or
decrease the numeric value.
Select the part of the
address to change
5. When you finish changing an address in the network menu,
press the
Enter
Auto/Enter
value.
6. When you're done making all necessary changes, press
to exit the menu system.
Opening and Closing EMP Monitor
To start EMP Monitor, click
Programs > EPSON Projector > EMP Monitor
If you've added the program to the Startup programs folder, it
may already be open. If so, click the icon in the system tray on
the lower-right corner of your screen to display the EMP
Monitor window:
To close EMP Monitor, right-click the program icon shown
above, then select
, as
6/03
button (on the remote control) or the
button (on the projector). This stores the
Start > Programs or All
Click here to start EMP Monitor
.
Exit
Increase or
decrease
the value
ESC
.