Epson PowerLite 61p Lamp Replacement Update

Epson powerlite 61p: supplementary guide

Hide thumbs Also See for PowerLite 61p:

Download this manual See also: Operating Manual, User Manual

Lamp Replacement Update

Please substitute the lamp replacement instructions below for the instructions in your Epson

PowerLite

61p/81p User's Guide:

1. Press the P

Power

unplug the power cord.

2. If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool).

Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to

avoid injury.

3. Use a screwdriver to loosen the screw holding the lamp cover. (The cover is on top of the

projector.)

4. Slide the cover out, then lift it off.

6. Use the screwdriver to loosen the two screws holding the lamp in place. You can't remove them.

button twice to turn off the projector. When the projector beeps twice,

Page 1 2. If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool). Warning: Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury.
Page 2 Then slide the cover closed and tighten the screw. 12. Reset the lamp timer as described in the User’s Guide. Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc. 7/04...

Powerlite 81p