The remote control doesn't work.
■
Make sure the toggle switch is in the correct position: set to
buttons, or to
■
Make sure you're within 19 feet of MovieMate, and within range of its front or back
sensor (approximately 30° left or right, and 15° above or below).
■
You may need to replace the remote control's batteries. Make sure they're inserted with
the positive (+) and negative (–) ends positioned as shown in the battery compartment.
■
Some discs don't support all of the remote control's functions.
■
If you're using a "universal" remote control, it might not work with MovieMate. Epson
does not support any third-party remote controls.
Solving Picture and Sound Problems
The picture is blurry or out of focus.
■
Adjust the focus using the focus ring. See page 15 for instructions.
■
Make sure the lens cover is off.
■
There may be dirt on the lens. Clean the lens as described on page 41.
■
Make sure the lens is not fogged by condensation. If you've just moved MovieMate from
a cold environment, wait approximately an hour before using it. If condensation forms,
unplug MovieMate and wait an hour or two before use.
■
Make sure MovieMate is placed the correct distance from the screen: no closer than
2.9 feet and no farther than 48.6 feet.
■
Adjust the
■
If you're using the
want to decrease the projection angle to reduce the amount of keystone correction
needed. Try adjusting MovieMate's position relative to the screen.
■
If you're using external video equipment, check the solutions on page 54.
52
Problem Solving
to use the other functions of these buttons.
Func.-
setting. See page 37.
Sharpness
adjustment, be aware that it lessens image quality. You may
Keystone
to use the numeric
-123