Yamaha YZ450FX 2019 Owner's Service Manual page 75

1. Clutch cable
2. Throttle cable (return)
3. Throttle cable (pull)
4. Cable holder
5. Warning light lead
6. Intake air temperature sensor coupler (black)
7. Rectifier/regulator coupler
8. AC magneto lead
9. Battery band
10.CCU (Communication Control Unit)
11.Starter relay diode
12.Radiator fan motor fuse
13.Starter motor lead
14.Gear position switch lead
15.Lower engine bracket
16.Protector (clutch cable)
17.Radiator hose
18.Gear position switch coupler
19.AC magneto coupler
20.Tension arm
21.Rectifier/regulator lead
22.Wire harness
23.Yamaha diagnostic tool coupler
24.Tank rail
25.Mode switch lead
26.Radiator
27.Cylinder head breather hose
28.Rectifier/regulator
29.Crankcase cover
30.Crankcase
31.Clamp
32.Frame
33.Plate
34.Warning light coupler
A. Pass the engine stop switch lead and the
mode switch lead between the frame and the
cable holder. Route engine stop switch lead
and the mode switch lead above of the vehi-
cle.
B. Insert the Yamaha diagnostic tool coupler into
the connector, and fix it to the bracket.
C. Fasten the engine stop switch coupler to the
bracket of the inside. Fasten the coupler (not
used) to the bracket of the outside. Route the
mode switch lead under the bracket.
D. Pass the warning light lead over the wire har-
ness and radiator hose.
E. Fasten the warning light coupler to the
bracket.
F. Fasten the rectifier/regulator coupler to the
bracket. Attach the coupler cover.
G. Pass the AC magneto lead through rear side
of the vehicle. No pinch is allowed between
the radiator and the tension arm.
CABLE ROUTING DIAGRAM
H. Fasten the starter motor lead to the bracket
using the plastic locking tie. Position the lock
part of the plastic locking tie to rear side of
the vehicle. Cut the end of the plastic locking
tie.
I. Route the starter motor lead along the cylin-
der body without slack.
J. Route the gear position sensor along the
crankcase without slack.
K. Pass the gear position switch lead to the
inside of the lower engine bracket (the side of
the vehicle).
L. Pass the clutch cable with no downward sag
allowed.
M. Bring the protector of the clutch cable into
contact with the radiator hose, and pass it to
the outside of the neutral switch lead and the
AC magneto lead (the outside of the vehicle).
N. No pinch is allowed the leads between the
radiator and the tension arm.
O. After connecting the gear position switch cou-
pler, attach the coupler cover.
P. After connecting the AC magneto coupler,
attach the coupler cover.
Q. Pass the rectifier/regulator lead to the inside
of the tension arm (the side of the vehicle).
R. Pass the main harness to the front of the radi-
ator hose (the front of the vehicle), and to the
inside of the throttle cable (the side of the
vehicle).
S. Pass the engine stop switch lead between the
Yamaha diagnostic tool coupler and the tank
rail.
T. Pass the warning light lead under the mode
switch lead.
U. Clamp the clutch cable at the front of the lead
(the front of the vehicle).
2-32