Yamaha YZ450FX 2019 Owner's Service Manual page 164

• Pass the engine stop switch lead through the
middle of the clutch lever holder.
2
0 mm
(0 in)
3
1
0 mm
(0 in)
6. Install:
• Right grip "1"
• Collar "2"
Apply adhesive to the tube guide "3".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Install the grip to the tube guide so that the grip
match mark "b" and tube guide slot "c" form the
angle as shown.
b
1
7. Install:
• Start switch
• Rubber cover "1"
• Throttle grip "2"
TIP
Apply the lithium-soap-based grease on the
throttle grip sliding surface.
30 50˚
FW D
0 mm
4 5
(0 in)
64 64
c
3
4-36
1
8. Install:
• Throttle cables "1"
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handlebar.
9. Install:
• Throttle cable housing "1"
• Screw (throttle cable housings) "2"
Screw (throttle cable housings)
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
EWA19310
WARNING
After tightening the throttle cable housing
screws, check that the throttle grip "3"
moves smoothly. If it does not, retighten the
screws for adjustment.
HANDLEBAR
2