Checking The Indicators; Operation Indicator; Lamp Indicator; Temperature Indicator - Epson EMP-8200 Quick Reference Manual

Page 70 of Owner's Manual

Checking the indicators

The projector is equipped with indicators that alert you to problems with projector operation.
The following tables show what the indicators mean and how to remedy problems that they indicate.

Operation Indicator

Problem and remedy
Indicator status
Standby condition.
This is the only time when the power cord
Illuminated
can be disconnected.
in Orange
Projection will start a few moments after
has been pressed.
Cool-down in progress.
Blinking
After while, the projector switches to the
in Orange
standby condition (the indicator lights orange).
Illuminated
Projecting in progress.
in Green
Warm-up in progress.
Blinking
After warm-up is complete, projection
in Green
will start when an image signal is input.
Internal problem.
Blinking
Stop using the projector and ask for projector
in Red
to be repaired. *1
Extinguished The power is not switched on.
*1 If an indicator is showing a status which does not appear in the previous tables,
Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package.
*2 Contact your dealer for a spare lamp.

Lamp Indicator

Indicator status
Operation indicator
Blinking
in Red
Lamp indicator
Blinking
Temperature
in Orange
indicator
Extinguished

Temperature Indicator

Indicator status
Power
Illuminated
in Red
Blinking
in Red
Blinking
in Orange
Extinguished
contact your dealer or nearest address provided at "International
Problem and remedy
Lamp error.
Remove the lamp and check if it is broken.
If the lamp is not broken, reinstall it. If the lamp
is broken, replace it with a new lamp. *2
Nearing the time for replacing the lamp.
Prepare a new lamp. *2
The power has not been switched on or normal
projection is in progress.
Problem and remedy
Excessive internal temperature (overheating).
The lamp goes off automatically and projection
becomes impossible. Wait for approximately 5
minutes with the projector in that state. After 5
minutes has passed, pull out the power plug
and re-insert it.
Power
After re-inserting it, press the and turn on
the power again.
Internal problem.
Stop using the projector and ask for projector
to be repaired. *1
High-speed cooling in progress.
If the internal temperature rises any higher,
projection will stop.
Check that the air inlet and exhaust vents are clear
and that the indoor temperature is not too high.
The power has not been switched on or normal
projection is in progress.
Troubleshooting
14