Equipment; Epa 2010 And Later And/Or C.a.r.b. Tier Iii - Echo EA-410 Operator's Manual

Hide thumbs Also See for EA-410:
Table of Contents

Advertisement

EA-410

Equipment

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved
attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices,
attachments or accessories which have not been tested and approved by ECHO. Read and comply
with all safety instructions listed in this manual and safety manual.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Check that the auger is firmly attached and in safe operating condition.
• Ice blades are very sharp. Wear gloves when handling or replacing.
• Do not use any attachment, accessory, or replacement part unless it is recommended in the Operator's
Manual.
• Have repairs done only by an authorized ECHO Service Dealer.
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.
ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete
stop before removing obstructions, clearing debris, or servicing unit.
DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
NEVER reach into any opening while the engine is running. Moving parts may not be visible through
openings.
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury or property damage may occur.
Have unit repaired by an authorized servicing dealer before using.
EMISSION CONTROL (EXHAUST & EVAPORATIVE)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM (engine modification)
and, if the second to last character of the Engine Family on the Emission
Control Information label (sample below) is "C", "K", or "T", the emission
control system is EM and TWC (3-way catalyst). The fuel tank/fuel line
emission control system is EVAP (evaporative emissions). Evaporative
emissions for California models are only applicable to fuel tanks.
An Emission Control Label is located on the engine. (This is an
EXAMPLE ONLY, information on label varies by engine FAMILY).
X7504220703
© 10/2013 ECHO Inc.
EMISSION CONTROL (EXHAUST & EVAPORATIVE)
9

Advertisement

Table of Contents
loading

Table of Contents