Disassembly - JVC RX-ES9SL Service Manual

3.1 Main body section
3.1.1 Removing the top cover
(See Figs.1 and 2)
(1) From the back side of the main body, remove the three
screws A attaching the top cover. (See Fig.1)
(2) From the both sides of the main body, remove the four
screws B attaching the top cover. (See Fig.1)
(3) Remove the top cover by moving up the back part of the top
cover and release the six joints a using a longer driver from
the inside. (See Fig.2.)
Note:
•Do not damage any part and board inside the main body when
releasing the joints a using a longer driver.
3.1.2 Removing the front panel assembly
(See Figs.2 to 4.)
• Prior to perform the following procedures, remove the top cov-
er.
(1) From the top side of the main body, cut the tie bands and
disconnect the wire from the connector
board. (See Fig.2.)
(2) From the bottom side of the main body, remove the four
screws C attaching the front panel assembly. (See Fig.3.)
(3) From the both sides of the main body, release the joints b
and remove the front panel assembly in the direction of the
arrow. (See Fig.4.)
(4) From the top side of the main body, remove the screw D at-
taching the earth wire on the DC power board. (See Fig.2.)
References:
• After attaching the front panel assembly, bundling the wires
using the new tie bands.
• When attaching the screw D, attach the earth wire with it.
Front panel assembly
1-6 (No.MB127)
All manuals and user guides at all-guides.com
SECTION 3

DISASSEMBLY

CN451 on the main
C
Fig.3
Top cover
A
Fig.1
Joints a
Main board
CN451
Tie bands
Fig.2
Front panel assembly
Joint b
Fig.4
B B
x2 x2
Front panel assembly
Earth wire
D
DC power
board