Removing and mounting the blade
• Please check if the blade is deformed or damaged
before removing and mounting it.
Removing the blade
►
1. Hold the main body in front.
2. Push the metal part of the blade
to the left with the thumb's belly.
• It is no problem when touch the
blade by fingers.
• Be careful not to let the blade fall.
Mounting the blade
►
Fit the mounting hook (
(
) on the main body and then push in until you
A
hear a click.
A B
PB017538 - ER-GK75
_(01GB)_04-04-19.indd 15
) into the blade mounting
B
Click
Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
(See this page.)
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
Replacement part
►
Replacement part is available at your dealer or Service
Centre.
Replacement part for
Blade
ER‑GK75
• Do not use any blade other than the one dedicated as
it may cause defect in performance.
WER9500
15
2019/4/4 15:09:12