Printing On Special Media - Epson Stylus Photo 960 User Manual

Epson stylus photo 960: specifications

Hide thumbs Also See for Stylus Photo 960:

Basic manual (108 pages)

Product information sheet (4 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

Make sure you have a new ink cartridge before you begin.

Once you start replacing a cartridge, you must complete all

the steps in one session.

1. Make sure the printer is turned on and not printing. (The

green P power light should be on, but not flashing.) Then

open the printer cover.

2. Press and release the H ink button. The print head moves to

the left, and the cartridge that needs to be replaced stops

under the _ ink out mark.

Ink out

mark

3. Press and release the H ink button again.

❏ If more than one ink cartridge is empty, the next

cartridge moves under the _ ink out mark. This

happens after you press the H ink button for every ink

cartridge that needs to be replaced.

❏ If all the empty cartridges have been identified, the print

head moves to the ink cartridge replacement position.

4. Open the cartridge cover.

5. Press in the tab on the back end of the empty cartridge to

unlock it. Then squeeze both tabs, lift the cartridge out of

the printer, and dispose of it carefully.

Warning: If ink gets on your hands, wash them thoroughly

with soap and water. If ink gets into your eyes, flush them

immediately with water.

6. Remove the new cartridge from its package.

Caution: Don't touch the green circuit board on the back of

the cartridge; you may inhibit normal operation and printing.

7. Slide the new cartridge into its slot. The side with the green

circuit board goes in the back of the slot.

8. Press the cartridge down until it clicks into place.

9. If you need to replace any other ink cartridges, repeat steps

5 through 8. Then close the cartridge cover.

10. Close the printer cover and press the H ink button. The

printer moves the print head and begins charging the ink

delivery system.

The lights flash and the printer makes noise. Charging takes

about one minute. When it's finished, the P power light

stops flashing and stays on.

Caution: Never turn off the printer while the Ppower light

is flashing, unless the printer hasn't moved or made noise

for more than 5 minutes.