Indoor Unit - Panasonic CS-PS9NKH Service Manual

10.2 Indoor Unit

10.2.1 How to Fix Installation Plate
The mounting wall shall be strong and solid enough to prevent if from the vibration.
The center of installation plate should be at more than
The distance from installation plate edge to ceiling should more than
From installation plate left edge to unit's left side is
From installation plate right edge to unit's right side is
○
B : For left side piping, piping connection for liquid should be about
: For left side piping, piping connection for gas should be about
1 Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
o
a level gauge.
2 Drill the piping plate hole with ø70 mm hole-core drill.
Putting measuring tape at position as shown in the diagram above.
o
The hole centre is obtained by measuring the distance namely 128 mm for left and right hole
respectively. Another method is intersection point of arrow mark extension.
The meeting point of the extension arrow mark is the hole center position.
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor
o
side. (refer to step 10.2.2)
10.2.2 To Drill a Hole in the Wall and
Install a Sleeve of Piping
1 Insert the piping sleeve to the hole.
2 Fix the bushing to the sleeve.
3 Cut the sleeve until it extrudes about 15mm
from the wall.
When the wall is hollow, please be sure to use the
sleeve for tube assembly to prevent dangers
caused by mice biting the connection cable.
4 Finish by sealing the sleeve with putty or
caulking compound at the final stage.
CAUTION
at right and left of the wall.
.
.
.
from this line.
43
from this line.