Epson Stylus Photo 895 Setup Manual page 5

Note:
Do not open the ink cartridge packages until just before you install them, or the
ink may dry up.
Follow the steps below to install the ink cartridges.
1. Open the output tray and the printer cover, then
turn on the printer by pressing the P power
button.
2. Lift up the ink cartridge clamps, as shown here.
c
3. Remove only the yellow tape
from the ink cartridges.
c
Copyright © 2001 by SEIKO EPSON CORPORATION, Nagano, Japan.
Caution:
Do not move the print head by hand. Doing
so may damage the printer.
Caution:
You must remove the
yellow tape seals from
the cartridges before installing them, or the cartridges will
become unusable and you will be unable to print.
If you have installed an ink cartridge without removing the
yellow tape seal, you must remove that cartridge and install a
new one. Prepare the new cartridge by removing the yellow tape
seal before installing it in the printer.
Do not remove the blue portion of the tape seal from the
cartridges, or the cartridges may become unusable.
Do not remove the tape seals from the bottom of the cartridges,
or ink will leak out.
Do not touch the green IC chip on the side
of the cartridge. Doing so may prevent
normal operation and printing.
Do not remove the green IC chip from the
side of the cartridge. If you install an ink
cartridge without a chip, the printer may
be damaged.
Do not touch this part.
Printed in Japan 01.xx-xx