Problems And Solutions; Setup And Software Installation Problems - Epson Stylus Photo 825 Printer Basics Manual

Problems and Solutions

Setup and Software Installation Problems

The printer makes noise after ink
cartridge installation.
When you install ink cartridges,
the printer must charge its print
head for a few minutes. Wait
until it's finished (the green
Processing
before you turn off the printer,
or it may use excess ink the next
time you turn it on.
If the printer stops moving or
making noise, but the green
Processing
after 5 minutes, turn off the
printer. If the light is still
flashing when you turn it back
on, contact EPSON as
described on page 98.
Make sure the ink cartridge
clamps are locked down
completely and no packing
material remains in the printer.
Turn off the printer, wait a
moment, then turn it back on to
clear the error.
88
Solving Problems
light stops flashing)
light is still flashing
You're having problems installing
the printer software.
Turn on your printer and make
sure its cable is securely
connected at both ends. Follow
the installation steps on the
Start Here sheet, and make sure
your system meets the
requirements on page 101.
Close other programs, including
screen savers and virus
protectors, and install again.
If the icon doesn't
SP825
appear in the Macintosh
Chooser, you may have an
extension conflict. Turn off any
unnecessary extensions and
restart your Mac.
If you see an error message in
Windows 2000 or Windows
XP, you may not have software
installation privileges. Contact
your System Administrator.
If you're using Windows 98,
Me, 2000, or XP, make sure
your system was not upgraded
from Windows 95; the USB
driver may not install correctly.