Chapter 3 Appendix; Configuring A Raid Set - Gigabyte X570S AERO G User Manual

Chapter 3 Appendix
3-1

Configuring a RAID Set

RAID Levels
Minimum Number of
Hard Drives
Number of hard drives *
Array Capacity
Size of the smallest drive
Fault Tolerance
Before you begin, please prepare the following items:
• At least two SATA hard drives or SSDs.
use two hard drives with identical model and capacity).
• Windows setup disc.
• Motherboard driver disc.
• A USB thumb drive.
Configuring the Onboard SATA Controller
A. Installing SATA hard drive(s) in your computer
Install the hard drives/SSDs in the SATA/M.2 connectors on the motherboard. Then connect the power connectors
from your power supply to the hard drives.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Steps:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Under
Settings\IO Ports, set SATA Configuration\SATA Mode to RAID. Then save the settings and restart your
computer. (If you want to use NVMe PCIe SSDs to configure RAID, make sure to set NVMe RAID mode to
Enabled.)
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
(Note 1) An M.2 PCIe SSD cannot be used to set up a RAID set either with an M.2 SATA SSD or a SATA hard
drive.
(Note 2) Refer to "1-8 Internal Connectors," for the installation notices for the M.2 and SATA connectors.
RAID 0 RAID 1
≥2
Size of the smallest drive (Number of hard drives/2) *
No
(To ensure optimal performance, it is recommended that you
(Note 1)
(Note 2)
- 46 -
RAID 10
2
Size of the smallest drive
Yes Yes
4