Gigabyte X570S AERO G User Manual page 35

& System Memory Multiplier
Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD
data. (Default: Auto)
& FCLK Frequency
Allows you to set the FCLK frequency. Options are: Auto (default), 667MHz~4000MHz.
& UCLK Mode
Allows you to specify the UCLK mode. (Default: Auto)
ƒ Advanced Memory Settings
ƒ Memory Subtimings
d Standard Timing Control, Advanced Timing Control, CAD Bus Setup Timing, CAD Bus
Drive Strength, Data Bus Configuration
These sections provide memory timing settings. Note: Your system may become unstable or fail to boot
after you make changes on the memory timings. If this occurs, please reset the board to default values by
loading optimized defaults or clearing the CMOS values.
ƒ SPD Info
Displays information on the installed memory.
& Power Down Enable
Enables or disables Power Down support. (Default: Auto)
& CPU Vcore/Dynamic Vcore(DVID)/VCORE SOC/Dynamic VCORE SOC(DVID)/CPU VDD18/
CPU VDDP/DRAM Voltage (CH A/B)/DDRVPP Voltage (CH A/B)/DRAM Termination (CH A/B)/
VDDP Voltage Control
These items allow you to adjust the CPU Vcore and memory voltages.
ƒ CPU/VRM Settings
This submenu allows you to configure Load-Line Calibration level.
(Note) This item is present only when you install a CPU that supports this feature.
/VDDG Voltage Control
(Note)
- 35 -
(Note)