Troubleshooting - Westinghouse WRC614SC Installation & User Manual

TROUBLESHOOTING GUIDE
PROBLEM
The cooker hood will not start
The cooker hood is not working
The cooker hood has switched off
during operation
If you have completed all of the above checks and are still experiencing difficulty, please contact your local Electrolux
Service Centre.
NOTE: This product is fitted with a safety cutout device.
• If the cooker hood is installed to close to the cooktop, flame cooking, operating the cooktop without cooking
utensils and blocked filters may activate the safety cutout device. If the hood stops during operation, correct the
faults and allow time for the safety cutout device to reset, the cooker hood will then function correctly.
• Do not operate cooktop without pots/pans.
• Do not flambe under cooktop.
REMEDY
Check that the hood is connected to an electrical supply
Check that a fan speed has been selected
Check that the fan speed is set high enough for the task
The grease filters are clean
The kitchen is adequately vented to allow the entry of fresh air
If set up for recirculation, check that the charcoal filter is still effective
If set up for extraction, check that the ducting and outlets are not blocked
Do not operate cooktop without pots/pans
Do not flambe under cooktop
The safety cut-out device has been tripped – turn off the hob and wait for
the device to reset. Check and clean filters. If the hood has been installed
below the heights indicated in the installation instructions the motor will cut
out frequently which will damage the hood.