Frothing Milk - Morphy Richards FoodFusion Manual

47060 rev5_47060 Rev 1 20/09/2011 12:24 Page 8
immediately and thoroughly.
Set the automatic
timer function
NOTE: The timer function can
be set when the coffee maker
is brewing or when it is in
standby.
Press the programme button
1
Ù. The display will change to
show the previous set time
and cup selection flashing. If
no previous setting has been
made or the machine has
been unplugged from the
socket since the last setting,
the default setting will be
shown; 12:00 and full carafe.
UK Helpline 0844 871 0960
8
N
Select ¯ the desired number
2
of cups that want to be
1 / 2
brewed, or full carafe (see
'Cup selection function' on
page 11). The cup selector
indicator will stop flashing.
Press the hour  and minute
3
˜ buttons to set the desired
time. The start time will stop
flashing.
O
NOTE: The programming
mode indicator continues to
flash to show the display is
still in programming mode.
If the programme button Ù
4
is pressed again or if no
buttons are pressed within 5
seconds, the cup selection
setting and the start time are
P
memorised.
To activate the automatic
5
timer function, press AUTO
button ı.
• The display will change to
show the programmed time
and cup selection setting for
5 seconds. The display will
then change to show the
Q
time, the automatic timer
function indicator will
illuminate to show the
automatic timer function is
set.
• With the automatic function
activated, the coffee maker
will turn on at the desired
time and start to brew the
coffee.
NOTE: If the AUTO button ı
is pressed during the brewing
process, the machine will
switch off and the automatic
timer function will be
activated.
If setting the automatic timer
function during the brewing
process, wait until the
process is complete before
pressing the AUTO button.
Press the AUTO button ı
6
again to cancel the automatic
function, the timer function
indicator will disappear. The
machine will keep in the
memory the cup selection
setting and the start time
until it is unplugged from the
Replacement Parts 0844 873 0726
mains socket.
To change the start time and
7
the number of cups, repeat
steps 1-5.
WARNING: Remember to
fill the water tank with
water and the filter with
coffee before activating
the auto function.
NOTE: The clock is a 24 hour
clock.
If no buttons are pressed, the
display will revert to the time
display within 5 seconds.

Frothing milk

It is advised to start heating
your milk ready for frothing
when you start making the
coffee. This helps to ensure
the milk reaches it's optimum
frothing temperature.
Fill the stainless steel jug fl
1
with the required amount of
milk. Do not exceed the
maximum level.
Place the jug on the hot plate
2
Î N and push the frother
hot plate  ON/OFF switch
to the 'ON' O position, the
hot plate indicator will light
up.
Once the coffee is brewed
3
(and the auto keep warm 
indicator lights up), the milk is
ready to froth.
Engage the frother system by
4
turning the frother control
lever ‰ to the right P, the
motor will start automatically
and the milk frother device
ON indicator Ò will
illuminate.
Frothing should take between
30-60 seconds.
NOTE: Frothing time can vary
depending on the type of
milk used and it's starting
temperature. We recommend
to use semi skimmed milk
from the fridge.
Ireland Helpline 1800 409 119