The PGA299 MCU emulator system then looks like in the picture below:
A PGA256 MCU system will look like in the picture below:
2.1.11 Check DIP switches on the Target System (e. g. MB90V390 Starter Kit)
2.1.12 Connect the MB2147-01 Emulator to a PC or a LAN network
© Fujitsu Microelectronics Europe GmbH
MB2147 – Installation Guide
Chapter 2 Setting up the Emulation System
The Emulator has three different communication
interfaces.
•
USB
•
RS232
•
LAN
Choose one of these communication interfaces.
- 15 -
The DIP switches on the
Flash-Can-120-390
Kit
has
to
be
set
illustrated in the left pictures.
For Single-Chip-Run Mode
only switch No. 3 has to be
switched ON.
MCU-AN-390070-E-V29
Starter
as