Brother MFC-J890DW Manual page 11

If the ink contacts your skin or gets into your eye or mouth, follow these steps immediately:
• If your skin comes into contact with the ink, wash your skin with water and soap
immediately.
• If the ink gets into your eye, rinse it with water immediately. If left as is, it may cause redness
or mild inflammation of the eye. In case of any abnormality, consult with your doctor.
• If the ink gets into your mouth, spit it out, rinse your mouth, and consult your doctor
immediately.
DO NOT run your hand over the edge of the paper. The thin and sharp edges of the paper
may cause an injury.
• Be careful not to get the ink in your eye when replacing ink cartridges.
• Keep ink cartridges out of the reach of children.
• Avoid swallowing ink.
• DO NOT shake ink cartridges unless specifically instructed to do so. Ink may leak if the
cartridge is shaken or twirled.
• DO NOT dismantle ink cartridges. The ink may get in your eyes, or on your skin.
IMPORTANT
• A distinct change in the product's performance may indicate a need for service.
• DO NOT connect your product to an electrical socket controlled by wall switches or
automatic timers, or to the same circuit as a large appliance or other equipment that
requires a significant amount of electricity. It could disrupt the power supply. Disruption of
the power supply may also delete information from the product's memory, and repeated
cycling of the power supply can damage the product.
• We recommend that you use our genuine ink cartridges to replace cartridges that come with
the device. Non-genuine ink cartridges may cause damage to the print head. They may also
result in differences in the colours or storage stability. (Not all non-genuine ink cartridges
cause these issues.)
• DO NOT put objects on top of the product. Doing so may cause the product to malfunction.
• If the product does not operate normally when the operating instructions are followed, adjust
only those controls that are covered by the operating instructions. Incorrect adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal operation.
11