Control Panel; Regulatory Approvals - Epson Stylus Color 900N User Manual

Ethernet Card Specifications
Your EPSON Type B Ethernet Interface Card (C823632) lets
you connect the printer directly to your network.
status sheet
button
10BaseT/100BaseTX connectors
Environmental
Temperature
Operation 41 to 95 °F (5 to 35 °C)
Storage 22 to 158 °F ( 30 to 70 °C)
Humidity (without condensation)
Operation 20 to 80% RH
Storage 5 to 95% RH
Vibration
Operation 5 to 55 Hz at 0.4 G
Storage 5 to 55 Hz at 1 G
Shock 4 G
Network Software Supported
NetWare 3.1x, 4.1x, or 5
EtherTalk (AppleTalk )
TCP/IP protocol
1pr, ftp over TCP/IP protocol
NetBEUI over TCP/IP protocol
Network Connectors and Signal
Assignments
RJ-45, ISO/IEC 8802–3 12.6 MDI Specification

Regulatory Approvals

EMC FCC part 15B Class A
Reliability
MTBF 268,973 hr (power on, 100% duty)
link selection light
status lights

Control Panel

The four lights on your printer's control panel show the
printer's status and alert you to problems like paper jams.
black ink
out light
color ink
out light
cleaning button
P is on The P power light is on when the printer is on and ready to
print. It flashes when the printer is receiving a print job or
performing a maintenance operation, such as cleaning the
print head.
S flashes When the S paper out light flashes, you have a paper jam.
Turn off the printer and gently pull out all paper. Make sure
none of the sheets are curled, creased, old, stuck together,
or too thin. Then reload the stack against the right edge
guide and slide the left edge guide over to the paper's left
edge. Then turn the printer on.
S is on When the S paper out light comes on, your paper is out or
incorrectly loaded. Make sure none of the sheets are curled,
creased, old, stuck together, or too thin. Then reload the
stack against the right edge guide and slide the left edge
guide over to the paper's left edge. Press the E load/eject
button to resume printing.
B or A
When an ink out light flashes, your ink supply is low. Make
flash sure you have a replacement cartridge.
B or A When an ink out light comes on, you need to replace the ink
are on cartridge. See page 8 for instructions.
P and S When the P power and S paper out lights flash and the
B black and A color ink out lights come on, jammed paper
flash,
and may be blocking movement of the print head. Turn off the
B and A
printer, wait a few seconds, and turn it back on. If no paper
are on ejects, turn off the printer, remove the jammed paper, and
turn it on again. If the lights still flash or stay on, contact
your dealer or EPSON.
P S B A
When all the lights flash, your printer may have an internal
flash error. Make sure you removed all the packing material as
described on the unpacking sheet in your printer box. Then
turn off the printer, wait a few seconds, and turn it on again.
If the lights still flash or stay on, contact your dealer or
EPSON.
P S B A
When all the lights are off, the printer is not receiving
are off power. Try these solutions:
Make sure the printer is turned on.
Turn off the printer, plug in the power cord securely,
and turn on the printer again.
Make sure the outlet is not controlled by a switch or
timer and is operable.
3/99
EPSON Stylus COLOR 900N
paper out light
power button
load/eject button
EPSON Stylus COLOR 900N
power
light
- 5