VTech Safe & Sound BM1100 User Manual page 20

Appendix
Troubleshooting (continued)
My parent unit plays any sounds from the baby unit and
I think it is too noisy.
• You may need to adjust the speaker volume on the parent unt
(page 12).
My parent unit does not play any sound when there is
noise from the baby unit.
• Make sure the parent unt s powered up by connectng t to AC
power (page (page 5) or to the rechargeable battery pack provded ( (page
3).
• Make sure the power adapter and the parent unt are plugged n
correctly and securely (page
• Make sure the parent unt s turned on (page 12) and the speaker
volume s not set to
• The parent unt may be too far away from the baby unt. Move the
parent unt closer to the baby unt (but not less than 1 metre).
• If the parent unt s powered by the provded battery pack, make
sure there s sufficent charge. Charge the battery n the parent unt
for up to 11 hours.
• Other electronc products such as HAM rados and DECT cordless
phones can cause nterference wth your audo montor. Try
nstallng your audo montor as far away as possble from these
types of electronc devces.
• Large obstructons may mpact the recepton. Try to relocate the
baby unt, away from large obstructons such as walls and doors.
• Completely remove and nstall the battery agan. Turn on the baby
unt and the parent unt. Allow up to one mnute for the parent unt
and the baby unt to synchronze.
The LOW BATTERY light flashes on the parent unit.
• Charge the battery n the parent unt for up to 11 hours.
• Completely remove and nstall the battery agan and use t untl fully
depleted, then recharge the battery n the parent unt for up to 11
hours.
• If the above measures do not correct the problem, replace the
battery.
(page 5). .
(Volume off)
15
(page 12).