Installing The Io Board - Dell Vostro 13 5310 Service Manual

6. Lift the I/O board along with its cable off the palm-rest and keyboard assembly.

Installing the IO board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
2. Place the I/O board on the palm-rest and keyboard assembly.
3. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
4. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
5. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the palm-rest and
keyboard assembly.
6. Replace the screw (M2x3) that secures the left-display hinge to the palm-rest and keyboard assembly.
7. Replace the screw (M2x4) that secures the left-display hinge to the palm-rest and keyboard assembly.
8. Connect the I/O-board cable to the connector on the I/O board and close the latch.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
42 Removing and installing components