Table of Contents
Advertisement
Before you call for service...
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit GEAppliances.ca. You may not need to call for service.
Problem
Dryer doesn't start
Dryer doesn't heat
Dryer shakes or
makes noise
Greasy spots on clothes
Lint on clothes
Static occurs
Inconsistent drying
times
The Dry dryness level
was chosen but load is
still damp
10
Possible Causes
Dryer is unplugged
Fuse is blown/circuit breaker
is tripped
Fuse is blown/circuit breaker is
tripped; the dryer may tumble
but not heat
Gas service is off
No heat temperature
selected
Some shaking/noise is normal.
Dryer may be sitting unevenly
Impreper use of fabric softener
Drying dirty items
with clean oness
Clothes were not
completely clean
Lint filter is full
Improper sorting
Static electricity can attract lint
Overloading
Paper, tissue, etc, left in pockets
No fabric softener was used
Over-drying
Synthetics, permenent press
and blends can cause static
Type of heat
Load consists of a mixture of
heavy and light fabrics
Exhaust system is blocked
What To Do
• Make sure the dryer plug is pushed completely into the outlet.
• Check the house fuse/circuit breaker box and replace fuse or
reset breaker. NOTE: Most electric dryer use two fuses/breakers.
• Check the house fuse/circuit breaker box and replace both
fuses or reset both breakers. Your dryer may tumble if only
one fuse is blown or one breaker is tripped.
• Make sure gas shutoff at dryer and main shutoff are fully open.
• Select another heat setting.
• Move dryer to an even floor space, or adjust leveling legs as
necessary until even.
• Follow directions on fabric softener package.
• Use your dryer to dry only clean items. Dirty items can stain
clean items and the dryer.
• Sometimes stains which cannot be seen when the clothes are
wet appear after dryung. Use proper washing procedures
before drying.
• Clean lint screen before each load.
• Sort lint producers (like chenille) from lint conllectors (like
corduroy).
• See suggestions in this section under Static.
• Separate large loads into smaller ones.
• Empty all pockets before laundering clothes.
• Try a fabric softener.
• Bounce® Fabric Conditioner Dryer Sheets have been approved
for use in all GE Dryers when used in accordance with the
manufacturer's instructions.
• Try a fabric softener.
• Adjust setting to Less Dry ot Damp Dry.
• Try a fabric softener.
• Automatic drying times will vary according to the type of
heat used (electric, natural or LP gas), size of load, types of
fabrics, wetness of clothes and condition of exhaust ducts.
• When combining heavy and light fabrics in a load, choose
More Dry if you are using a sensor cycle.
• Inspect and clean exhaust system.
Advertisement
Table of Contents
