Install The Ion 1000 By Replacing An Existing Router - PaloAlto Networks ION 1000 Hardware Reference Manual

Install the ION 1000 by Replacing an Existing
Router
Install the ION 1000 to replace an existing router, directly terminating the MPLS, especially in environments
where routers are not already present or required.
Configure the ION 1000 as a drop-in replacement for the WAN Router. This mode is most useful for saving
cost at new sites that are designed without a traditional router in mind.
While this mode is used to remove an existing router at a site, it is sometimes preferred to deploy with
an existing router. In such a scenario, the existing router is unplugged or disabled after all functions are
verified.
ION 1000 HARDWARE REFERENCE | Install the ION 1000
31
2021 Palo Alto Networks, Inc.
©