Table of Contents
Advertisement
Converting from LP to NG
WARNING! You must have an authorized service technician perform this
procedure. If these instructions are not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life . Lloyd's Material
Supply (L .M .S .) will not be held responsible for an improperly converted gas grill .
All Cal Heat grills are manufactured as standard liquid propane (LP) grills and can be converted to burn
natural gas (NG). There are two steps required to convert a grill from LP to NG.
both steps.
Step 1: Switching the regulator behind the grill
Step 2: Changing the burner orifices
You will need some or all of the fittings (depending
on the size of the grill or cart) contained in
the conversion kit provided with the grill. The
conversion kit contains orifices to convert five
main burners, two small rear infrared burners,
one large infrared burner, and two side burners.
You will not need all of the parts in the kit.
Before you begin, make certain the LP gas source
has been disconnected from the grill. If you have
a cart, you do not need to remove the grill from
the cart.
To gain access to the NG regulator:
•
For grills, tilt the grill forward.
•
For barbecue carts, remove the back cover.
Step 1: Switching the regulator behind the grill
The regulator in the image below has been removed from a grill to illustrate this
procedure.
1.
Remove the LP gas line.
2.
Remove the cap fitting from the end of the NG gas regulator.
3.
Place the cap fitting over the LP gas inlet.
4.
Insert the 3/4" flared in the NG gas regulator.
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
You must perform
You will need:
•
13mm open end
wrench
•
3/4" flared fitting
•
Pipe compound
www.calspas.com
21
Advertisement
Table of Contents
