Epson FX-1050 Product Information page 2

FX - 850/1050 DOT - MATRIX PRINTER
Humidity:
Operation: 10% to 80% (without
condensation)
Storage: 5% to 85% (without condensation)
Shock: Operation: Up to 1 G within 1 ms
Storage: Up to
Vibration:
Operation: Up to 0.25 G at up to
Storage: up to 0.50 G at up to 55 Hz
SelecType 1
I
You can use the SelecType control panel to choose fonts, pitches, and
condensed printing. The settings you select using the SelecType panel
remain valid even after the printer is turned off. reset, or initialized.
However, commands from your software application program
temporarily override the SelecType settings.
Character fonts
The FX-850 and FX-1050 have three built-in character fonts:
ROMAN
W e ' v e j u s t s e e n y o u r e x c e l l e n t a d f o r
m i n i a t u r e z e b r a s i n a r e c e n t b a c k i s s u e o f
T r a d e r T i m e s . W h a t i s t h e p r i c e o f t h e s e
i t e m s f o r q u a n t i t i e s o f m o r e t h a n o n e g r o s s ?
SANS SERIF
w x y z c :
W e ' v e S e e n y o u r e x c e l l e n t a d f o r
j u s t
m i n i a t u r e z e b r a s i n a r e c e n t b a c k i s s u e o f
W h a t i s t h e p r i c e o f t h e s e
i t e m s f a r q u a n t i t i e s o f m o r e t h a n o n e
Interface timing
The figure below shows the timing for the parallel interface.
Initialization
There are three ways that the printer can be initialized (returned to a
fixed set of conditions).
Hardware initialization
When the power is turned on
l
When the printer receives an INIT signal at
l
the parallel interface (pin 31 goes LOW).
Software initialization Software sends the ESC @ (initialize the
l
printer) command.
FX - 850/1050 - 2
G within 7 ms
2
55 Hz
a b c d e f g h i j k l m n o p q r s t u v
g r o s s ?
1 2 / 1 2 / 8 8
Epson Extended Graphics Character Table
L
Italic Character Table
Default Settings
The table below shows the default conditions that become valid when
the printer is initialized.
In addition, the data buffer is cleared when the printer is initialized by
turning on the power or by an INIT signal.
Note: The user-defined character set is not cleared
initialized.
the printer is
when
9 - Pin Printers