Table of Contents
Advertisement
HOW TO INSTALL THE SEAT
1.
Carefully remove the plastic bag from the seat.
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
NOTE: Fasteners may be attached to seat for shipping
purposes, if so remove fasteners before proceeding.
2.
Align the holes in the seat hinge to the holes in the seat
(Figure 2). Fasten the seat to the seat hinge with the fasteners
as shown.
HOW TO ASSEMBLE THE STEERING WHEEL
Tools Required: 3/8" Socket Wrench
Attach the steering wheel as follows:
(A)
25x3
1.
Make sure the front wheels point forward.
2.
Slide the bellows over the steering post (Figure 3).
NOTE: Before attachment of the steering wheel, make sure
that the front wheels point forward and are straight. For
proper alignment of the steering wheel, see Figure 3.
3.
Slide the steering wheel onto the steering post.
4.
Use the fasteners shown above to secure the steering wheel.
The fasteners are shown at full size. Tighten the screw until
snug and then add 1/4 turn. DO NOT over tighten.
5.
Attach the cover to the steering wheel.
6.
Some models have an optional decal in the parts bag. Attach
the decal to the center of the steering wheel as shown.
1740336SM
ASSEMBLY
3.
(B)
17x47
(C)
17x146
13
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Decal
(Optional)
Bellows
Steering Post
Seat
Seat Hinge
Seat
Adjusting Hole
B
A
Figure 2
Cover
A
C
Steering Wheel
Straight
Figure 3
Advertisement
Table of Contents
