International comfort products N8MXL Installation Instructions Manual page 29

Figure 34 − Horizontal Left Application−Vent Elbow Left
SEE NOTES: 1,2,4,7,8,9 on the page
following these figures
Figure 35 − Horizontal Left Application−Vent Elbow Right
then Up
SEE NOTES: 1,2,4,5,7,8,9 on the page
following these figures
Figure 36 − Horizontal Right Application−Vent Elbow
SEE NOTES: 1,2,4,7,8,9 on the page
following these figures
Figure 37 − Horizontal Left Application−Vent Elbow Up
SEE NOTES: 1,2,4,5,7,8,9 on the page
following these figures
441 01 1421 01
Right
Specifications are subject to change without notice.
Figure 38 − Horizontal Right Application−Vent Elbow Left
SEE NOTES: 1,2,4,5,7,8,9 on the page
A03213
following these figures
Figure 39 − Horizontal Left Application−Vent Elbow Right
SEE NOTES: 1,2,4,5,7,8,9 on the page
following these figures
Figure 40 − Horizontal Right Application−Vent Elbow Left
A03214
A03214
Venting Notes for Figure 28 − Figure 40
1. For common vent, vent connector sizing and vent
material: United States−−use the NFGC.
2. Immediately increase to 5−inch (127 mm) or 6−inch
(152 mm) vent connector outside furnace casing when
5−inch (127 mm) vent connector is required, refer to
Note 1 above.
3. Side outlet vent for upflow and downflow installations
must use Type B vent immediately after exiting the
furnace, except when Downflow Vent Guard Kit, is
used in the downflow position.
4. Type−B vent where required, refer to Note 1 above.
A03215
then Up
SEE NOTES: 1,2,4,5,7,8,9
A03219
A03216
A02068
29