Tires, Seat; General Lubrication - Ariens Imperial RM1028 Owner's/Operator's Manual

1
1. Battery
2. Battery Cover
3. Battery Strap
Figure 10
IMPORTANT: DO NOT fast charge. Charging at higher
rate will damage or destroy battery.
T
IRES
NOTE: Keep tires properly inflated at all times. For proper
tire inflation when working under various conditions, refer
to chart below. Use a low pressure tire gauge for
accurate pressure readings.
Front
Back
Check tire pressure at least once a month. Over inflation
may cause operator discomfort and excessive tire tracks
on lawns or soft surfaces, while under inflation causes
short tire life.
NOTE: After checking and/or inflating, replace and
tighten valve caps to prevent air loss.
16
5
3
4
6
2
4. Positive Terminal (+)
5. Negative Terminal (–)
6. Filler Caps
14 psi
14 psi
Ariens
S
EAT
Clean seat regularly, using a vinyl cleaner (not solvent).
Extreme temperatures can damage seat when left
unprotected against weather. If seat should tear, apply
vinyl repair tape to protect damaged area.
G L
ENERAL UBRICATION
IMPORTANT: Wipe each grease zerk fitting clean before
and after lubrication. Keep grease and oil off belts to
avoid slippage and deterioration.
Apply Sten Mix Hi-Temp Grease or equivalent to the lube
fittings. Order P/N: 00036800 - three pack of 3 oz.
cartridges or 00036700 - ten pack of 14 oz. cartridges.
Apply oil at lubrication points.
The steering system, front wheels, left rear wheel and
linkage pivot points (figure 11) should be lubricated every
25 hours of operation, or twice each season, whichever
occurs first.
®
Riding Mower
Figure 11
11/99