Table of Contents
Advertisement
6. Note that the printer prints on the underside of the paper.
Make sure your paper has a clean, straight edge. Fit the
first three holes of the paper over the sprocket pins, and
then close the sprocket covers. Slide the left sprocket unit
to remove any slack in the paper. Then push the lock lever
down to lock it in place.
7. Turn on the printer. It advances the paper to the loading
position automatically upon receiving data.
Note:
If the printer runs out of paper during a print job, load additional
paper on the push tractor and then press the FF button.
Tips for using continuous paper
If you want to change the top-of-form position
permanently, adjust it with the default-setting mode as
described in Chapter 3.
Paper Handling 2-9
Advertisement
Table of Contents
