Yamaha NIKEN MXT850 Owner's Manual page 19

Right
1
3
2
1. Stop/Run/Start switch " /
2. Drive mode switch "MODE"
3. Hazard switch " "
Dimmer/Pass switch "
Set this switch to " " for the high
beam and to " " for the low beam.
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
/ "
the switch down towards "
page 5-1 for starting instructions prior
to starting the engine.
EAU73921
Set this switch to "
/ /PASS"
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
EAU66040
tion, use this switch to turn on the haz-
"
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
". When
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
Instrument and control functions
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU66030 gine not running, otherwise the bat-
"
tery may discharge.
EAU66060
Cruise control switches
/ / "
See page 3-8 for an explanation of the
cruise control system.
", and then push
". See
"MENU" switch
This switch is used to set the clock,
" to stop the en-
display brightness, and shift indicator
light. (See page 3-11.)
"SELECT" switch
This switch is used to make setting
EAU66010
changes within the multi-function me-
" posi-
ter unit. (See page 3-11.)
Drive mode switch "MODE"
See page 3-18 for an explanation of
the drive mode.
3-4
ECA10062
3
EAU84250
EAU84520
EAU84530
EAU84260