Main PCB Disassembly Procedures
Removing the Side Panel and Side Connector PCB
Chapter 6 - Disassembly/Reassembly Guide
This section describes the items that may be removed/replaced from the main
PCB assembly of the monitor. The main PCB assembly is separable from the
front case assembly.
Step 1. First separate the front and rear assemblies as described in the section
"Separation of Front and Rear Case Assemblies" on page 45.
Step 2. Then remove the main PCB assembly from the front case assembly, as
described on page 49.
Step 1. Use needle-nose pliers or a Tinnerman tool to remove the two
Tinnerman fasteners securing the white plastic side panel to the
underside of the main PCB.
Step 2. The side panel is attached by screws to the side connector PCB.
Remove this assembly from the main PCB by pulling it straight up,
disconnecting the multipin connector at J3 on the main PCB.
Main PCB Disassembly Procedures
Tinnerman nut
59