Canon iP4680 Simplified Service Manual page 4

LED
(Blinking in
orange)
11 times Failed in automatic print
head alignment.
13 times The remaining ink
amount unknown.
14 times Ink tank not recognized. [1684]
15 times Ink tank not recognized. [1410 to
16 times No ink (no raw ink).
19 times Non-supported hub
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
Error
Error
code
[2500]
[1683]
1419]
[1688]
[2002]
Solution
Press the Resume/Cancel button
to clear the error, then perform the
automatic print head again.
(In the iP4600 / iP4680, use Matte
Photo Paper MP-101.)
Replace the applicable ink tank
with a new one. Printing with a
once-empty ink tank can damage
the printer.
To continue printing without
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the remaining
ink amount. After the operation, it
is recorded in the printer
EEPROM that the function to
detect the remaining ink amount
was disabled.
A non-supported ink tank (an ink
tank that is sold in a different
region from where the printer was
purchased) is installed (the ink
tank LED is turned off). Install the
supported ink tanks.
A hardware error occurred in an
ink tank (the ink tank LED is
turned off). Replace the ink
tank(s).
Replace the empty ink tank(s),
and close the scanning unit
(cover).
Printing with an empty ink tank
can damage the printer.
To continue printing without
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the remaining
ink amount. After the operation, it
is recorded in the printer that the
function to detect the remaining
ink amount was disabled.
Remove the applicable USB hub
from the PictBridge (USB)
connector.
(4/21)
Remarks
The ink tank installed
is judged to have once
been empty.