Replacing The Photoconductor - Epson AcuLaser CX11N User Manual

Replacing the Photoconductor

Handling Precautions
Always follow these precautions when replacing the
photoconductor:
❏ The photoconductor weighs 6.16 lb (2.8 kg). Be sure to
hold it firmly by the handle when carrying it.
❏ Avoid exposing the photoconductor to light any longer than
necessary.
❏ Be careful not to scratch the surface of the drum and belt.
Also, avoid touching the drum; oil from your skin may
permanently damage its surface and affect print quality.
❏ Do not store the photoconductor in an area subject to direct
sunlight, dust, salty air, or corrosive gases (such as
ammonia). Avoid locations subject to extreme or rapid
changes in temperature or humidity.
❏ Do not tilt the photoconductor.
Warning:
Keep the photoconductor out of the reach of children.
Do not dispose of a used photoconductor in fire, as it may explode
and cause injury. Dispose of it according to local regulations.
Removing and Replacing the
Photoconductor
1. Make sure the CX11N is turned on.
2. Remove any paper loaded in the ADF (CX11NF only).
3. Slowly flip back the scanner until it stops.
4. Close the output tray extension.
Epson AcuLaser CX11N/CX11NF
5. Lift up cover B.
6. Pull up the orange lever inside cover B.
7. Lift out the photoconductor using its handle.
8. Remove the new photoconductor from its package and pull
off the protective sheet.
8/05 Epson AcuLaser CX11N/CX11NF 13
-