Table of Contents
Advertisement
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
Motion sensor:
Press and hold M
LED indicator blinks slowly in
green (page 7).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel without registering the
sensor, press M
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the motion sensor
by using the [Home Network] app, you
can assign a name to your devices and
group them by location.
For more information, refer to the
User's Guide (page 14).
Information about
sensor features
The motion sensor utilises an infrared
sensor (i.e., heat sensor).
Please read the following information
before deciding where to install the
motion sensor.
Note:
R The motion sensor's sensor features
are not designed to be used in
situations that require high reliability.
We do not recommend use of the
OTHER
N until the
N on the hub and
motion sensor's sensor features in
these situations.
R Panasonic takes no responsibility for
any injury or damage caused by the
use of the motion sensor.
Using heat to detect motion
The motion sensor's infrared sensor
can detect motion by recognizing
temperature differences that occur
within the range of the sensor. It does
this by detecting the infrared rays that
are emitted naturally by people,
animals, etc., which correlate to the
object's temperature. The detection
range is indicated in the illustration by
the grey area in front of the motion
sensor.
Detection range when looking from
above
Horizontal detection range:
1
approx. 90°
Setup
1
9
Advertisement
Table of Contents
