Table of Contents
Advertisement
Setup
Wall mounting
There are two methods for wall
mounting the motion sensor. To mount
the sensor flat against the wall, use the
rear cover. To mount the sensor so that
it faces 45° to the left or right, use the
wall mounting adaptor.
Mounting examples
cover and wall mounting adaptor
1
A Rear cover
*1
View of looking from above.
Note:
R Mount the motion sensor on the
stable location where the motion
sensor can be adequately supported
when mounting.
R Do not mount motion sensor on a
soft material. It may fall down, break
or cause injury.
R Do not mount the motion sensor on
the following places: gypsum board,
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm thick, etc.
12
*1
of the rear
2
B Wall mounting
adaptor
Using the rear cover
1
Remove the rear cover by
pressing the upper sides of the
cover (A) and sliding it down (B).
2
Attach the rear cover to the wall by
using screws (
R Place the rear cover with "UP"
mark facing upwards.
R
37 mm
2
1
1
A
B
).
1
UP
2
U P
Advertisement
Table of Contents
