Cadillac 2010 DTS Owner's Manual page 263

fade, press the knob until the speaker control labels
display. Continue pressing to highlight the desired label,
or press the pushbutton positioned under the desired
label. Turn the knob to adjust the highlighted setting.
The highlighted setting can be adjusted by pressing
either SEEK arrow,
the desired levels are obtained.
To quickly adjust balance or fade to the middle position,
press the pushbutton positioned under the BAL or
FADE label for more than two seconds. A beep sounds
and the level adjusts to the middle position.
To quickly adjust all speaker and tone controls to the
middle position, press the
two seconds until a beep sounds.
This feature is used to provide a choice of four different
listening experiences. DSP can be used while listening
to the audio system or a CD. To change the DSP mode,
press the knob until the DSP control label displays.
To adjust balance or
FWD, or REV buttons until
knob for more than
Press the pushbutton located under the DSP label until
the control labels display. Continue by pressing the
desired button below the control labels on the display.
For more information on the control label displays, see
the following:
: Select this screen button to adjust
the audio for normal mode. This provides the best
sound quality for all seating positions.
: Select this screen button to adjust
the audio for the driver to receive the best possible
sound quality.
: Select this screen button to adjust the audio
for the rear seat passengers to receive the best
possible sound quality.
button to enable Bose
processing circuitry. Centerpoint produces a
full vehicle surround sound listening experience
from a CD, MP3/WMA, or XM stereo digital audio
source and delivers five independent audio
channels from conventional two channel stereo
recordings. (Not available for AM, FM, or auxiliary
sources.)
DSP is only available on vehicles that have the Bose
Premium audio system.
: Select this screen
®
Centerpoint signal
4-97