Kenmore W11024188A Installation Instructions Manual page 18

3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a
5/8" (1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall
on regulator so that the solid end faces out and the
marking "ê NG" is facing the direction shown in the
above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Propane to
Natural Gas)
1. Remove burner cap.
2. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
C
X-Large Burner
A. Burner cap
B. Burner base
C. Choke (for use with x-large burner, propane
only)
18
Side view before
D
E
Side view after
B
C
D
A
B
3. Apply masking tape to the end of a 9/32" (7 mm) nut
driver to help hold the gas orifice spud in the nut driver
while changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4. Gas orifice spuds are stamped with a number on the side.
Replace the propane orifice spud with the correct Natural
gas orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas
orifice spud placement.
Remove choke from X-Large burner base.
Natural Gas Orifice Spud Chart
Burner Rating Color
19,000 BTU (ST) White/Gray
18,000 BTU Blue
17,000 BTU (ST) N/A
17,000 BTU White/Blue
15,000 BTU White/Green
9,200 BTU White/Black
8,000 BTU White/Yellow
5,000 BTU White/Orange 1.00
1,200 BTU Black
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top left-hand side of the oven door for
proper sizing of spuds for each burner location.
5. Place propane orifice spuds in the orifice spud bag.
IMPORTANT: Keep the propane orifice spuds in case
of reinstallation with propane.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
To Convert Oven Bake Burner (Propane
to Natural Gas)
1. Remove the oven racks and the oven door. See the "Oven
Door" section.
2. Remove 2 screws and washers at the rear of the oven
bottom.
D
A
Size (mm) ID Number
1.84 184
1.94 194
1.75 175
1.90 190
1.80 180
1.35 135
1.25 125
100
0.52 52