Enterasys ANG-1000 Installation & Service Manual page 72

Configuring General Values of the ANG-3000/7000 with APM
When using AutoLink Recovery (ALR), only one VPN Domain Name is
assigned and shared by both primary and secondary systems. But, using
more than one VPN name for multiple systems linked over a network is
allowed with the exception of those systems used in an ALR setting. Refer
to the RiverMaster Administrator's Guide for more information about ALR.
3 Select the ANG type: either Remote (a stand-alone ANG) or Local (an
ANG with an accompanying APS).
If you are configuring a local ANG, after completion of the General
window you will be directed to continue set up using the RiverMaster
management application. If you are configuring a remote ANG, you will
be permitted to continue set up using the Aurorean Policy Manager Web
utility.
4 Specify a Hostname for the ANG.
5 Click the Enabled or Disabled Intelligent Client Routing button.
When Intelligent Client Routing (ICR) is enabled on a local ANG,
Aurorean users can browse the Internet directly, outside the tunnel.
For remote ANGs, it indicates that ANGs will dynamically exchange
routing information and will update networks at the remote sites. For
more information on ICR, refer to the RiverMaster Administrator's
Guide.
We strongly recommend you enable ICR for site-to-site tunnels. To
disable ICR for this configuration, consult Enterasys Customer Support.
6 For local ANG configuration only, enter the IP Address of the APS. If
you are configuring a remote ANG, skip to Step 8.
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
Chapter 3